|
楼主 |
发表于 2015-3-13 15:55:40
|
显示全部楼层
本帖最后由 oliver 于 2015-3-13 23:58 编辑
It‘s not easy to understand "低耐久值螺栓" 是什么螺栓?
To fully undersatand, full sentences are copied as beneath:
“upon tightening on light-metal components, the E-modulus of aluminum bolt, smaller by a factor of three as compared to steel bolts, generates joints with higher resilience as they can else be achibed. For instance, only by means of reduced-shaft bols. As a consequence thereof, working loads applied cause smaller additional bolt loads which is of particular advantage under dynamic loads and, moreover, results in smaller preload losses during settling and creeping processes. Hence, they absolutely seen low durability values of aluminum bolts of at least +/-20 MPa (at an average preload of 0.7x Rp0.2) are overcompensated to maintain safe joints even under alternating loads”
|
评分
-
查看全部评分
|